Electronics Forum | Wed Jan 05 10:22:55 EST 2005 | Mike B
We're getting an error on our CP643 that we can't seem to make sense of. It's a D1 axis error, but we're only getting it when we run a feeder on device 140. Any advice would be appreciated.
Electronics Forum | Tue Dec 06 05:40:12 EST 2005 | ajay
we also faced similar problem in fuji cp643. addition to your suggestion - mainly in program PCB thickness, component height checked & set correctly , then problem solved.
Electronics Forum | Tue Jul 22 19:45:27 EDT 2008 | crashoveride
0402 on CP643 is not that good.... We use the Fuji NXT for this part. However, nozzle configuration can be edited thru machine configuration, nozzle set- up.
Electronics Forum | Wed Apr 29 16:13:53 EDT 2009 | jimmyboz
Hit the help key while cursored on that category,(televideo monitor) if the sticker wore off, its one of the keys in the upper right, below the the F keys, above the number key pad, let me know if you got it.
Electronics Forum | Mon Nov 09 02:39:38 EST 2009 | martinphill
No the machine is not capacity constrained. We do not use IPC-9850. Rated CPH is taken from Equipment manufaturer. Fuji-CP643. Universal HSP4796 We have 3 manufaturing units at different location Difficult to standardize OEE calculation
Electronics Forum | Tue Aug 23 11:09:27 EDT 2011 | nworr
Wondering how long does it usually take to do a weekly/monthly/quarterly service? Currently we have one person that does the service and I really don't think it should take him as long as it does.
Electronics Forum | Tue Feb 28 21:18:49 EST 2012 | skatemo
Hello friend, also cleans the clutches, several times but he continues presenting the same problem. I suspect in a few holders that we buy, for that from that they established themselves I present this fault
Electronics Forum | Wed Feb 29 10:00:48 EST 2012 | cyber_wolf
In order to clean the clutches properly, you must disassemble them. Did you do that ? The nozzle holder sensor dogs must be clean and scratch free.
Electronics Forum | Mon Oct 01 11:20:14 EDT 2012 | jimmyboz
What exactly are you looking for, a service call, phone support, an emergency contact, or all of the above?
Electronics Forum | Thu Jul 26 10:02:46 EDT 2018 | cyber_wolf
Load part on 0201 feeder Install .4mm nozzles in machine Load program and press start button. Feeders, nozzles and machine must be within factory specifications.
